In the use of the reducer, it is inevitable to encounter the case of too big vibration, the work of the reducer is not stable, a long time of vigorous shaking, will also make the service life of the reducer affected, so do you know the reason for the vibration of the reducer is too big? Below by small make up for you to explain:

1. Motor screw loosening: similar to coupling failure, when the motor vibrates for various reasons, the vibration will be transmitted to the reducer and the vibration of the reducer will increase.

2. Shaft deformation out of balance: when the strength and hardness of the shaft is lower than the requirements or aging due to long-term work will cause shaft deformation, shaft deformation will cause large vibration of the reducer.

3. Coupling damage: when the coupling connected with the reducer is damaged due to oil leakage, screw loosening and other reasons, its vibration will be transmitted to the reducer.

4. Severe bearing wear: as explained in 4.2.1, the above reasons will cause the reducer to fail to work normally.

5. Loose foundation screws: the reducer may loose or break the foundation screws due to long-term work.

Above is small make up for you to explain some of the vibration of the reducer is too big, I hope to help you.